Mad River Seat Truss Hardware Roto Kit (4 x Stainless 4 inch Screws , Nuts, Flat & Cup Washers)

For Roto seats

• Includes 4 Stainless steel screws, flat and finish washers, locknuts. This is enough to fit/connect one seat.

Note if swapping from a wooden seat to a roto-moulded seat (suits both front and rear seats) you will not need the hanging Truss system as the the plastic seats screw directly to the gunwale of  your canoe. For this reason the screws used are shorter than required for fitting the wooden seat through a seat truss.

There are variations of this kit. Typically these differ significantly only in the type of cup washers as well as the thread of the screws (metric/imperial). Each kit is consistent but if you are replacing only part of an existing set up make sure to use the correct or matching nut with bolt.

MPN 8063118 or 12437